Serving the Greater Toronto Area & beyondEnglish · हिंदी · ગુજરાતીFor Realtors →
(437) 227-6800WhatsAppcontact@jbminspect.ca
Cold rooms & uneven heating

One room is always colder than the rest of the house?

A cold bedroom, a drafty home office or a freezing floor above the garage often has a cause that can be narrowed down. We use thermal imaging and a careful look at the room and, where safe, accessible and within the agreed scope, the attic and garage, to show where the surfaces suggest heat is escaping or cold air is getting in, so you know who to call to confirm and fix it.

Sound familiar?

Common signs of a cold-room problem

Temperature

The room stays several degrees colder

The thermostat says 21 °C, but one bedroom, the basement office or the room at the end of the hall never gets there, especially on windy or very cold days.

Floors

The floor feels cold underfoot

Typical of rooms built over a garage, over a porch, or above a bay window or overhang where the floor sticks out past the wall below.

Drafts

You can feel moving air

Cool air near baseboards, electrical outlets on outside walls, window trim or an attic hatch.

Comfort

The heat runs, but the room never feels warm

Warm air comes out of the register, yet the walls, ceiling or floor feel cold to the touch.

Who this is for: homeowners with one or two uncomfortable rooms; parents setting up a nursery or a child's room; people working from a cold home office; and landlords or property managers responding to a tenant's comfort complaint, who arrange access and any required tenant notice.

What could be going on

A cold room usually has one of four causes, sometimes several

  1. Heat is escaping through the walls, ceiling or floor. Insulation can be missing, settled, compressed or not touching the surface it is meant to insulate. Corner rooms and rooms under a low attic lose heat on more sides.
  2. Cold outside air is getting in. Air leaks at the band joist (the wood around the top of the foundation), around windows and doors, at outlets and light fixtures, and at the attic hatch can make a room feel colder than its temperature suggests.
  3. Not enough heat is reaching the room. A long or leaky duct run, a duct that passes through a cold space, a closed damper or a weak return-air path can starve one room. Measuring airflow and balancing the system is work for a licensed HVAC contractor.
  4. The windows are the weak point. Older or damaged windows, failed seals and poorly sealed trim can make a room feel cold even when the walls are well insulated.

Thermal imaging helps tell these apart, because each tends to leave a different temperature pattern on the room's surfaces. It narrows the possibilities; it does not replace the trade who will make the repair.

Room over the garage

Why the floor above a garage is often cold

A bedroom over an attached garage has an unheated space directly under its floor. In winter the garage can be close to the outdoor temperature, so the floor needs to work like an outside wall: insulation that fills the space between the floor joists or sits tight against the underside of the subfloor, and an air barrier that stops garage air from moving through the floor.

Common weak points are insulation that has sagged away from the subfloor, gaps at the ends of the joists along the outside wall, and heating ducts running through the cold garage ceiling.

The same gaps that make the floor cold can also let garage air into the house. We note visible openings in the separation between the garage and the living space. Thermal imaging cannot test whether that separation is gas-tight. Ontario's Fire Code requires carbon monoxide alarms in homes with an attached garage; see the province's carbon monoxide safety page for where they must go.

Cross-section of a bedroom floor over an attached garage A diagram showing the bedroom above, the floor joists and subfloor, an insulation batt that has sagged away from the subfloor leaving a cold air gap, an air leak at the joist ends along the outside wall, a heating duct in the garage ceiling, and the cold garage below. Bedroom (heated) Cold floor felt here Subfloor Gap: cold air Sagging batt Batt tight tosubfloor Duct incold space Garage ceiling (drywall) Garage (unheated) Near outdoor temperature in winter Outside wall Air leak at joist ends
Simplified illustration. Actual floor assemblies vary, and what is inside a finished floor cannot be confirmed without opening it.
What we examine

What JBM Inspect looks at for a cold-room concern

  • The walls, ceiling, floor, windows and doors of the affected room, with thermal and regular photographs.
  • Comparable rooms elsewhere in the house, so you can see whether the pattern is unusual.
  • The attic above the room, where there is safe access, for missing or displaced insulation and air leaks.
  • The garage ceiling and accessible joist-end areas along the outside wall, for rooms over a garage.
  • Supply registers and the ducts we can see, to note obvious problems such as disconnected or uninsulated runs in cold spaces.
  • The basement band joist and other places where cold air commonly enters.

This is a non-invasive, visual and thermal assessment. We do not open walls, floors or ceilings, move stored belongings, or measure duct airflow.

Thermal imaging

What thermal imaging can and cannot establish here

It can help show
  • Surface areas that are colder than expected, consistent with missing or displaced insulation.
  • Streaks and fans of cold that suggest air leakage at trim, outlets, baseboards and hatches.
  • A floor over a garage that is colder in some joist bays than others.
  • Whether warm air is reaching a register, compared with registers in other rooms.
It cannot establish
  • What is inside the wall or floor, or the exact amount of insulation (R-value).
  • How much air the heating system delivers to the room, or why. That needs an HVAC contractor's measurements.
  • How much energy or money a repair will save.
  • That a cold pattern is caused by one thing only. Framing, ducts, pipes and furniture also change surface temperatures.

How findings are reported

Each item in the report is labelled, so a pattern on a thermal image is never presented as a confirmed defect.

In the reportWhat it meansExample (illustration, not a client finding)
ObservationWhat was seen, photographed or measured, with the conditions at the time.The floor near the outside wall reads several degrees cooler than the middle of the room on a cold morning.
Possible explanationWhat the observation is consistent with. Usually more than one explanation fits, and the report says which.Consistent with insulation not touching the subfloor, or with air leaking in at the joist ends. A duct in the garage ceiling could also contribute.
Confirmed findingStated only when the condition is directly visible or corroborated by a second method. Otherwise the report names the next step and who can confirm it.Confirmed only where it can be seen, for example displaced insulation visible at an accessible opening. Otherwise: an insulation contractor is recommended to open and confirm.
Conditions & limitations

When this works, and what can limit it

  • It has to be cold outside. Insulation and air-leak patterns only show reliably when there is a meaningful, steady temperature difference between inside and outside. A commonly used practical guideline is a difference of about 10 °C or more, held for several hours. It is a guideline, not a guarantee of results, and suitability is judged from the actual conditions. This is why the service is normally offered from October to April, but the actual weather on the day decides.
  • The house needs to be heated normally for several hours beforehand, with windows closed. Furniture and curtains pressed against outside walls hide what is behind them; moving them away the evening before gives better results.
  • Strong sun, rain and wind change the picture. Sun warming an outside wall can mask a cold spot inside for hours afterward. We record the conditions at the time of the assessment, and if they would make the results unreliable, we discuss options with you before going ahead.
  • Access limits what we can see. Finished basements, insulated attics without safe access and stored belongings in the garage reduce what can be assessed. We say in the report what we could not see.
What you receive & price

Two ways to book a cold-room concern

One localized room or draft can be booked as a Single-Concern Assessment. When several rooms are affected, or you want the problem room compared with the rest of the house, the whole-home Winter Interior Thermal Survey is the better fit. Tell us what you notice and we will recommend the smaller service where it is enough. These are focused services and do not include a complete home inspection.

ServiceCondo apartmentTownhouse / semiDetached
Single-Concern Assessment (one localized cold room or draft; up to 75 minutes on site)$279$279$279
Winter Interior Thermal Survey (the whole home, room by room)$299$349$395
Combined Thermal & Moisture Assessment (adds one defined moisture concern)$399$449$499

Plus 13% HST. Survey prices for condos cover up to 1,000 sq. ft. and for houses up to 2,500 sq. ft. above grade. Size and travel adjustments may apply and are confirmed before you book. A Single-Concern Assessment covers the room agreed before booking and, where relevant, safe and accessible attic or garage areas that serve it. It does not include a whole-home survey, exhaustive testing or a confirmed root cause.

  • Thermal screening of the agreed room (Single-Concern Assessment) or of accessible interior areas throughout the home (Winter Interior Thermal Survey), with paired thermal and regular photographs where useful.
  • Documentation of the conditions on the day and the limitations that applied.
  • A prioritized list of observations and recommended next steps, including which trade to call (for example an insulation contractor or an HVAC contractor).
  • A written report within two business days.

In short: JBM Inspect assesses one localized cold room, draft or cold floor over a garage as a Single-Concern Assessment for $279 + HST (up to 75 minutes on site), or the whole home as a Winter Interior Thermal Survey for $299 (condo), $349 (townhouse or semi) or $395 (detached). It shows where heat appears to be escaping or cold air entering, during suitable winter conditions, and recommends the next step. It does not measure duct airflow or insulation R-value.

Questions

Cold room FAQ

Should I book the $279 Single-Concern Assessment or the whole-home winter survey?

If one room, one floor area or one draft is the problem, the $279 Single-Concern Assessment is usually enough: up to 75 minutes on site for the concern agreed before booking. If several rooms feel cold, the whole house is drafty or you want the problem room compared with every other room, book the Winter Interior Thermal Survey ($299 condo, $349 townhouse or semi, $395 detached). We will tell you if the smaller service fits.

Should I call an HVAC contractor or a thermographer first?

If the furnace is not working properly, or no warm air comes out of the room's registers at all, call an HVAC contractor first. If the heating system seems to work but the room still feels cold, a thermal survey can show whether the walls, floor, windows or air leaks are part of the problem, which helps you brief the right trade.

Why is the bedroom over my garage so cold?

The floor sits over a space that is close to outdoor temperature in winter. If the insulation is not tight against the subfloor, the joist ends are not air-sealed, or ducts run through the garage ceiling, the floor can stay cold. A thermal survey on a cold day can show which joist bays and edges are colder, but it cannot confirm what is inside the floor without opening it.

Can you do this in summer?

Not reliably. Insulation and air-leak patterns need a meaningful temperature difference between inside and outside, which in the GTA normally means the heating season. If you are concerned about a room in summer, we can talk about timing, or about a moisture concern if that is the issue.

Will you tell me how much insulation to add?

No. We report where the surface patterns suggest insulation is missing, displaced or not performing, and recommend an insulation contractor or energy advisor for the design of the repair. We do not specify R-values or quote repairs.

Is this the same as an energy audit?

No. It is a qualitative thermal assessment. It does not include a blower-door test or an EnerGuide evaluation, and it does not calculate energy savings or confirm rebate eligibility.

Is one room always colder than the rest?

Tell us which room, what you notice and when it is worst. We'll confirm whether the weather suits a thermal survey, the scope and your total price before you book.

CallWhatsAppGet a Quote
Chat on WhatsApp